| Key (#) | CMP30257 |
| Cam Locks (Set of two) | LOK10001 |
To replace Cam Lock:
1. Open Lid and pry off “C” Clip. Take care not to lose small parts (“C” Clip and Wave Washer).
2. Using a 7/8” deep socket, back out large Hex Nut.
3. Remove old Cam Lock.
4. Mount new Cam Lock with Rubber Gasket in place.
5. Tighten large Hex Nut to a snug position (do not over tighten!).
6. Next, place the Wave Washer on the Hex Nut followed by the Cam.
7. Finaly, snap the “C” Clip in place to hold the cam.
Lobby - Showroom - Workshop - Office - Conference - Map