Installation Instructions:
The Flip Ring Cone Holder comes complete with one Cone Stop Bracket, Lower Grip Bracket, Cone Ring, and hardware.

1. Mount the Lower Grip Bracket to the Rack Leg 5 1/2” from top of bracket to bottom of Gater Foot. Use one Spring Nut, Flat Washer and Hex Bolt, as shown.

2. Next, mount the Cone Stop Bracket to the top of the Rack Leg with a Spring Nut, Flat Washer, and Hex Bolt, as shown. Be sure to leave room to adjust Cone Stop Bracket to fit Saftey Cone height.

3. Snap Cone Ring into existing holes in Gater Corner, as shown.

4. Insert Safety Cones and tighten Cone Stop Bracket in optimal position.

5. Check your work and be sure to tighten all bolts.

Installation is now complete.

Cone Ring (1)

(TGC01335)

(TGA01336)

(TGA01466)

5/16” x 1.25” Hex Bolt (1)

5/16” x 1” Hex Bolt (1)

5/16” Flat Washer  (1)

Brass Bushing (2)

(SSH60026)

(SSH60025)

(SSH60014)

(TGC01337)

(HDW60015)