Installation Instructions:
1. Remove Rear Cross Channel, and discard Spacers as shown in figure 1.
2. Peel and stick the Inner Channel Support Bracket, one at each end, as shown in figure 2.
3. Replace 21/2” Bolts with new 2 3/4” Bolts and mount Eyelets for Retainer Cables with existing hardware, as shown in figure 3.
4. Replace 5/16 - Hex Nuts with new Plastic Knobs, as shown in figure 3. Mount knobs facing toward the front of the vehicle.
5. The Rear Cross Channel can now be conveniently removed at any time without using tools.
Plastic Knobs (4)
Inner Channel Supports (2)
Retainer Cables
(Knob Lanyards) (4)
3M Peel N' Stick Tape Squares (4)
5/16- 18 x 2 3/4" Hex Bolt (2)
5/16" Nyloc Hex Nut (2)
(SSH60090)
(SSH60028)