Installation Instructions: Shell Shelf Pack (VSA - - - - -) and Portable Spool Carrier Shelf (VSS10003 & VSS10004)
 

Tools Required: 3/8" Drive Ratchet with 1/2" and 7/16" Sockets.
Installation Instructions:



First, attach the Bottom Shelf to the End Panel with the ¼" Button Bolts, Flat Washer, and Nyloc Hex Nut.
Mount bolts at both ends and tighten as shown. The Bottom shelf and two Ends Panels are now assembled.
Next, mount the Second Shelf, leave five open squares between the two shelves. Attach using the supplied Bolts, Washers, and Nyloc Hex Nuts.
Next, place Spring Nuts into Spool Shelf Support Channels. To mount simply insert the spring first then twist and adjust.
Four holes in the Bottom Shelf will align the four Spring Nuts in the Channels. Place Shelf End into grooves in Channels.
Tighten ½" Hex Bolts and Flat Washers. Now, mount the Spring Nuts to the Channels and mount the Spool Tray to the channels with ½" Hex Bolts and Flat Washers.
Finally, mount the front support bracket with ¼" Button Bolts, Flat Washers, and Nyloc Hex Nuts.
Assembly is complete. Note: The Spool Tray is offset according to the side of the vehicle the Shelf will be installed on. The Spool Tray shown is in position of the street side of the vehicle.
Back
Continue Gator Tour


Lobby - Showroom - Workshop - Office - Conference Room - Map

Copyright © 1999-2005 Tailgater Inc.