Installation Instructions: Water Jug Bracket, Rack Leg Mount (WJB10003)
Installation Instructions: The Water Jug Bracket mounts to the rack leg, curb side rear, as shown in figure 1.  Tools required for installation include two 1/2” Wrenches, hand drill, 3/8” Drill Bit and a center punch.  The Water Jug Bracket has two holes that are used for mounting.  Start with the lower hole first. Measure up 4.5” from the bottom of the leg and center on the leg (see fig. 2).  Mark, center punch and drill through one wall of the leg using the 3/8” drill bit.  Now mount the water jug bracket to this first hole with supplied hardware.  Find the second hole in the Water Jug Bracket and mark, center punch, and drill through the second hole.  Attach the second bolt and tighten.  Make sure both bolts are tightened securely.  A special bungee cord is supplied to secure water jug to bracket.
Hardware:
5/16”-18 x 1” Stainless Steel Hex Bolt (2)	5/16" Stainless Steel Flat Washer (2)	5/16” Nyloc Stainless Steel Hex Nut (2)
(SSH60031)	(SSH60014)	(SSH60028)
Back Lobby - Showroom - Workshop - Office - Conference - Map Copyright © 1999-2005 Tailgater Inc.